if you look on the inside edge of the air ducts it has little plastic lips for the mesh wire vents. just put one side (usually top or bottom) of the vent in the lips first and work the rest of it in. just make sure you put the vents in the correct side, simply hold it up to the opening to make sure it will fit correctly.

 

u should take the whole front off to get a better view & easier access. the whole air duct come right off after unhooking 2 push pins i believe? cant recall unless i look at the bike. with the airducts off the fairings its alot easier & no risk of scratching anything.:cheers

 

you dont need to take anything off, you can see it all if you just kneel down infront of the bike and open your eyes . Like gsxr600rida says start from the top then the bottom ... use needle nose pliers to hold the vent while you place it in its spot ... Should take minutes for both,,,,,, Not hard .. good luck

 

I had the same problem when I got my 06 750. I was only missing the left hand mesh (facing the bike). This is what I did, ordered the entire ram air duck took out the mesh
1.) pushed a shoe string through the top and bottom portion of the mesh
2.) slide the mesh in sideways
3.) pull on the shoe string and the mesh will stand up in the duck and snap into place.

took less than 1 min. Hope that helps, mine looks perfect.

 

Does anybody know the part number for these screens? Mine are missing and I looked them up on ronayers but cant find them on there. Thanks

 

once again you have to buy the whole ram tube not just te screen

 

thanks guys
I did the shoe lace trick and it worked perfect!!!
never would have thought of that
Thanks again

 

No problem...I had to order the whole duck from Oneida Suzuki like stated earlier. I got resourceful with my shoe strings after I noticed that I would've had to take off my motivation slider and the fairing. Anyway glad I could help!


BTW...its listed as and "intake pipe" on most OEM parts websites. RH...Right side, LH left side (Sitting on the bike)

 

280SQUAGGLER
nice avatar,
are you checking your mesh covers in that pic?
it's a little easier to pull over and check