Hi guys I am on the build of a gsxr1000 2005 So far I got the turbo, a gt28 Manifolds Low comp pistons Bov New set of engine bearings Oil feed tubes and splitter Checker valve Rods will be using wossner What else shal take into account? Do I need a upgrade oil pump gear or is stock good for...

2006 GSXR 750 Low voltage going to injectors causing them not activate I have a little over 9 Volts metered directly on my fuel injector harness (fuel injectors not connected). If I keep my positive lead connected to the harness and meter directly to the ground on the frame I get 12 + volts...

so I just purchased a 05 gsxr600 and the dash shorts out, so I opened up the section of the harness to find out that it had been tampered with and weather damage as well, trying to see if I can get a easy to read diagram to see where these wires supposed to be to correctly repair the section of...

Hi all, I am looking for general information regarding a bottom yoke (triple tree). I am in the process of grafting a GSXR 1000 front end onto an "83 750 Katana. I purchased a set of legs that were advertised on a well known auction site as GSXR 1000 K7 legs. I also purchased a set of yokes...

Before I am crucified for asking this question I went through all the pages and seen no talks on this. I see the older models had dual exhaust option so why no offering this time around???? I would highly consider that option and am thinking about seeing if it can be done custom. Thoughts Yay...