How are you mounting your lic. plate?

Handcranked Films · Mar 23, 2007

jefftward said:
Handcranked Films, sorry the thread got hijacked.

Not a problem. I'm going the under the buck route.

J4Rowell · Mar 23, 2007

check out the sticky at the top of the page, best DIY IMO. I rocked the corner brackets for a while but i thought it looked cheap. Changed over to the DIY. Much cleaner and it took like 15 mins and was free.

H0useofz · Mar 23, 2007

Here are pics of the compwerks LTD fender kit on the black one witch tucks wayunder and has a moveable hinge.the blue bike has the regualr compwerks fender kit. pics are kinda bad.

gilbmd01 · Mar 23, 2007

well i use something very original its two bolts and two nuts ta da!

FlipRN · Mar 24, 2007

Nice set up. I've got the competition works one, thats (hinges) and is bolted to the rear hugger. I like it, little pricey but who cares, its on there now.

ksstang · Mar 25, 2007

I've been seriously thinkin about orderin the competion werks one that mounts way down under. If anyone has any "better" pictures of it, would you mind postin them up? Thanks,

Kyle

Downshyft · Mar 26, 2007

jefftward said:
Walmart - pack of 4 corner brackets for $1 something. (You only use two)

What do you do with the plate light wires? The FAQ said to "tape them up" but this doesnt seem right...

xsists · Mar 26, 2007

take off the right turn signal side plastics and un-snap the clip and pull the wires out. I just did it this weekend, super easy.

How are you mounting your lic. plate?

Handcranked Films

J4Rowell

H0useofz

Attachments

gilbmd01

FlipRN

ksstang

Downshyft

xsists

Top Contributors this Month

Recommended Communities