http://motionpro.com/motorcycle/tools/product/pilot_screw_adjusting_tool/
does it work well? does it fit the head of our air screws?
does it work well? does it fit the head of our air screws?
anyone used one?
Gixxer 711
1 - 11 of 11 Posts
Joined
·
1,822 Posts
http://motionpro.com/motorcycle/tools/product/pilot_screw_adjusting_tool/
does it work well? does it fit the head of our air screws?
does it work well? does it fit the head of our air screws?
Joined
·
269 Posts
got one in my tool box. yes it does work and it takes a little while to get used to it. you have to hold it at just the right angle or the bit will bind in the screw hole. it is better than taking off the carbs to adjust them.
Joined
·
1,822 Posts
sweet! thanks!!
Dan,
I found I could adjust mine on the 1127 using the little driver bits you get for battery drills and cheap socket sets. You can use them between your thumb and forfinger.
Not easy and a mirror comes in handy, but it's possible.
Haven't tried it on the kettle yet
I found I could adjust mine on the 1127 using the little driver bits you get for battery drills and cheap socket sets. You can use them between your thumb and forfinger.
Not easy and a mirror comes in handy, but it's possible.
Haven't tried it on the kettle yet
Joined
·
2,248 Posts
I just about bought one a couple days ago and wished I had last night after removing the carbs about five times!
Joined
·
7,321 Posts
here's a better one seen in action works well but spendyGixxer 711 said:
http://motionpro.com/motorcycle/tools/product/90_degree_1-4_hex_driver/
Joined
·
3,344 Posts
Yea I have that first one, like someone said about it binding, it does, I ended up dremelling the edges on mine a 1/16 or something. my problem with it was it was hard to guage a full turn and telling if it was actually making contact. I thought it also didn't fully screw them in to the lightly seated position. with my 36mm's i was able to just use a screw bit by hand, and reach and bend and whatnot. cant do that with the 40's no room under 2/3 with starter.. 
Joined
·
442 Posts
i just broke down orderd the first (cheaper) tool, along w/ teh econamy carb synk tool and a set of tappet feeler gauges. ......... yeha........ more thigns to help me hold off on geting to ride my bike this week....... cuz why put it back into 1 piece if iv got tools to help do a better tune up on the way haha.......
1 - 11 of 11 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
