Suzuki GSX-R Motorcycle Forums Gixxer.com banner
1 - 3 of 3 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello,
I have a 2005 GSXR 750 which I have put into dealer mode and am getting the C00 error with the dash at the top. I have tried adjusting the TPS however regardless of what position it is I am getting the same error code.
I can’t find anything on what the issue is so does anyone have any ideas?
 

· You should listen to me. No, seriously, listen to
Joined
·
11,126 Posts
Huh? C00 means no error. Do you have the RPM at the correct value (probably 1200)? It's possible that your TPS is faulty. There are some resistance and voltage measurements that can be made. See the C14 error section in the service manual. Perhaps it's not properly connected.
 

· Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Hello, I can’t figure out how to type that dash that sits at the top just before the C00 but mines got that. It also runs a bit slow which I suspect is due to the TPS. Im getting between 800-1000RMP.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top