Suzuki GSX-R Motorcycle Forums Gixxer.com banner

1 - 2 of 2 Posts

·
Registered
2002 Gsxr 1000
Joined
·
15 Posts
Discussion Starter #1
I purchased an 02 1000 gsxr . when valves were adjusted i believe the timing was out a tooth as the bike is really lacking in bottom end.
Back of the intake valves are real dirty (like gummy and black). I did a leakdown and results we 3-5% yet compression test was real low across the board but all within a couple lbs. So i believe the problem is in the event. Has anyone else had this experience.?
 

·
Registered
2002 Gsxr 1000
Joined
·
15 Posts
Discussion Starter #2
I pulled cams and when I put #1 piston tdc then install the cams as listed in manual it make the #1 on the intake stroke not compression. So when I roll it and put it to compression the numbers on the cams are off 180° could this be by chance the cam gear on crankshaft improperly installed?
 
1 - 2 of 2 Posts
Top