Seat cowl
1 - 4 of 4 Posts
They are as rare as Hens teeth these days, Ebay is going to be your best bet. Airtech doesn't make one. I have two and have contemplated making a mold of the part, but haven't gotten around to it. I have seen some DIY efforts that used a pillion seat pan with a fiberglass lid, a lot of work but can be done.
I looked for one for a couple years. They do come up. Sometimes NOS even. Expect to pay $300 plus though.
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
93 GSX-R750 - Cylinder 3 Not Firing
Water Cooled GixxersHey guys. New to me 93 GSX-R 750. Bike starts and runs. I put a heat gun on all 4 pipes and noticed #3 was cool. I successfully tested for spark. It looked a little weak, but no different from #4. Plug is clean and doesn't smell like gas. I pulled the carb rack out and drained all of the...- 36
- 786
-
GSXR1100W trans troubles.....
Water Cooled Gixxersmy 7/11 project came to a halt today, nearly finished, put the chain on and noticed that it shifts into first or neutral, nto no availothing else, it wont go into second gear, no click, nothing I tried rotating the tire while manipulating the shifter lever to no avail I pulled off the clutch...- 3
- 43
-
Avengeusa1 · updated
-
I’m about to turbo my 95 750
Water Cooled GixxersI absolutely love this bike, it’s been through a lot with me and I’ve had this bike forever and don’t plan of getting rid of it 😂, anyways I work as a fabricator so the build process isn’t what worries me but the fact that I want to turbo this bike and all I have is YouTube videos to reference...- 0
- 46
-
Saultineo · updated
-
Looking for a chain/sprocket recemmendation
Water Cooled GixxersI have a 96 GSXR1100, I am looking for a chain and sprocket source, currently a 530 chain Best deal? I do like durability Best brand, i do like regina, have used them in the past, there are lots of chains and models of chains for each manufacturer I like steel sprockets as opposed to the...- 4
- 108
-
Avengeusa1 · updated
-
1100 wp forks
Water Cooled GixxersReplaced the fork seals and oil and forks are realy bouncy even on full rebound setting ? Iv heard the fork cap and the lock nut have to be a certain height on the damper rod. The sevice manual says screw cap on finger tight which iv done any advice guys- 1
- 67
Join now to ask and comment!