[Bosch]

Hello all,

Just thought I’d share my random RFID project I made for to replace the key. It’s a replacement front end for my yamaha XV so didn’t have the GSXR keys I also needed to fit a start button so thought I’d use the spare hole!

I also wanted it to match the hydraulic clutch and brake reservoir cap, just because..

I didn’t want the RFID to use any power so I’ve hooked it up to the clutch.. pull the clutch.. powers ups microcontroller.. then scan... powers up bike... scan again to turn bike off

Bit of designing and printing think it looks similar. The hole will be the push button

 

[Bosch]

This is the housing for the RFID micro controller etc and the screw top for the button. Using the original key bolts and then threading it on the top section

assembled on the triple

On the bike

Done! I’ll upload a video of it working!