[Jtztha1]

I have a 06 gixxer 600. I have installed a pc5 but I'm a lil unsure about the last connector on the pc5 I believe it's the one that should connect to the o2 sensor. Well wen I connect that one the bike runs shitty and is burning gas really rich intake it off it runs better but still I'm not sure that I'm getting the full effect of the pc5 can anyone give me some insight on this topic.

 

[bjoshua1002]

I have a 06 gixxer 600. I have installed a pc5 but I'm a lil unsure about the last connector on the pc5 I believe it's the one that should connect to the o2 sensor. Well wen I connect that one the bike runs shitty and is burning gas really rich intake it off it runs better but still I'm not sure that I'm getting the full effect of the pc5 can anyone give me some insight on this topic.

that is the MAF sensor. look at the position, just to be sure im not being dumb is the connector up at the level of the injectors, maybe on the frame. did you load a map? even if you loaded the right map including all the mods you have, the map will leave your bike rich. Rich is far better than lean. Regardless your loaded map really is just a crutch to get you to the dyno

 

[jbaker]

I dont think the engine has a 02 sensor. I have a PC5 on k6 1000 and I would need to weld an exhaust bung for the sensor and buy an autotune in order to change the tune while riding. Otherwise the ECU just adjust fuel table according to MAF?

 

[Cman750-RR]

Use Zero Map simple