I have a 2001 Intruder 1500, and I am getting a lot of oil in my air box. It seems to be coming out of the crank case breather tube. When I say a lot of oil I'm saying in about 30 to 40 seconds of running the engine at high rev I will have roughly a half a cup of oil in the air box. I don't understand why. Please help
Oil in my air box
1 - 3 of 3 Posts
Smell the oil for fuel. Its a real good chance that tour carbs are flooding fuel into the head and down into the crankcase, over filling it and pushing it out of the breather hose.
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Stator cover leak! Help!!
Oil and LubricationI have 2006 gsxr, I have had 4 oem gaskets put on, I’ve noticed it is leaking from exact same spot everytime. The last time I put on a gasket, I noticed by a screw hole there was some scarring on the metal and by the screw hole! Would this cause the leak? I contemplated putting a very thin layer...- 0
- 169
-
2007 gsxr 600 oil strainer
Oil and LubricationI just replaced my oil pan and oil strainer('07 600). The strainer basically just slides into the opening and there is grooved stay. The rubber strainer didn't seem particularly firm in place, with a good O ring washer also installed. Does the pan offer any support once installed. Thanks a bunch!- 2
- 412
-
750. K8 oil for track
Oil and LubricationSorry for another oil post..... I just did an oil change on my track only K8 and have filled with full synthetic but not started the bike yet as I'm a fraction short. I've just had 4L of Castrol Power1 delivered and it's Semi-syn. 1st thought was to send back but after a bit of Google it looks...- 9
- 379
-
Engine oil for Suzuki Gixxer.
Oil and LubricationDear Mates, hope you are fine, I was hoping to get some advice regarding which engine oil I should use on my Suzuki Gixxer 155? I've 5000+ kms running and previously used Shell Advance Ultra 10w40 Full Synthetic. Hoping to get your expert solutions fast. Thanks in advance. :woot **In addition...- 5
- 1K
-
suzuki oil filters
Oil and Lubricationjust cut one open and not impresses with the internals, looks to be the same construction as the old frams :piss which were pure crap, paper end caps that can come loose. Also made in china, been using Hi-flow for the past 20+ years and will defiantly be staying with those.- 6
- 705
Join now to ask and comment!