Suzuki GSX-R Motorcycle Forums Gixxer.com banner
1 - 4 of 4 Posts

·
Registered
Joined
·
361 Posts
Discussion Starter · #1 ·
Doing a track day and I was reading the NESBA rule book. Says I must have #'s 6 inches high to identify my bike. Where do you guys buy the tail plates,front plate and #'s from?
 

·
Registered
Joined
·
849 Posts
Use some duct tape and either check home depot, lowes, walmart, for numbers. Or just go to your nearest sign shop and get some numbers printed/cut for you in vinyl. Hope that helps.
 

·
Registered
Joined
·
3,003 Posts
The only place I found 6" numbers were at a motorcycle shop...they were 2.99 for 3 numbers so it's not expensive. With nesba you are only required numbers on the front of the bike with it recommended on the tail. What I did was take my smoke double bubble off and put my stock clear windshield on and put the 2 numbers on that...worked just fine and passed tech. Some people do the duct tape tripe too...not me I'll just leave the numbers on the stock clear and swap it out for the track.
 
1 - 4 of 4 Posts
Top