Suzuki GSX-R Motorcycle Forums Gixxer.com banner
1 - 8 of 8 Posts

·
Banned
Joined
·
16,404 Posts
Discussion Starter · #1 ·
know how the new bikes have'em but we dont??

well i found a place that has'em..
orme bros.inc.
1818 885 1414
nothridge,ca.
they will ask you what thread, tell'em FINE..
also if you have after market brake lines, where both lines
start at the master cylinder !!! tell them you need the double motherfucker..

they are fast(orme bros.) and reasonable($10)....and you can bleed the SOB ....
 

·
Registered
Joined
·
396 Posts
Lockhart Phillips has had them for a few years. Yoyodyne also carries them.
 

·
Registered
Joined
·
100 Posts
Hey, Spongebob, I take it that the thread pitch was fine on the master cylinder banjo bolt then??
 

·
Banned
Joined
·
16,404 Posts
Discussion Starter · #4 ·
YES it was...everone that has a srad should get one of these....sure make bleeding the fucker easy...
 

·
Banned
Joined
·
16,404 Posts
Discussion Starter · #6 ·
na, no pictures, you know what a bleeder valve is right?? you know that banjo fitting that attatches the brake line to the master cylinder?? well the fitting i have has that valve in the banjo fitting.. before the valve it was a motherfucker to get the air out..markbsae did mine sucsesfully, but we had to remove the brake lever/master cylinder from the clip on..this is simple now..
 

·
Registered
Joined
·
218 Posts
ok i thought that's what you meant. I might check it out.

maybe they make one for my CRF 450 too! (much more frequent bleeding and master cylinder rebuilding)
 

·
Banned
Joined
·
16,404 Posts
Discussion Starter · #8 ·
they make'em for everything..just know the thread size..
 
1 - 8 of 8 Posts
Top