Suzuki GSX-R Motorcycle Forums Gixxer.com banner
1 - 2 of 2 Posts

· Registered
Joined
·
112 Posts
Discussion Starter · #1 ·
Hi all, just got finishing some carb work on meez 96 750. Replaced the needle valves and seats. Noticed the needle valve were a little bit longer than stock. Adjustted as close to stock settings. Bike seems to run but kinda boggish and doesn't respond as quick (ie, on highway at 7000 rpm and twist the wrist. it accelerates but just not as fast as before). Dyno jet kit stage 1, Yoshi RS3 slip on. The tip of exhaust is sooty. I have the 132's and 130 mains as Dyno jet says, but should I go to 128 and 130 instead?? or reset my float height? Does float height play more of a role with a rich mixture here?

Thanks

RZR
 

· Registered
Joined
·
112 Posts
Discussion Starter · #3 ·
Thanks, i'll try some of your suggestions. Let's you know in a couple days. I think I will switch to the 130/128's and readjust float height. Thanks again for all your help.

Rzr
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top