Suzuki GSX-R Motorcycle Forums Gixxer.com banner
1 - 10 of 10 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hi guys so I bought a gsr600 few days ago and after two days FI code shown i checked the harness and it seemed like the previous owner got his own ground connection
Motor vehicle Automotive tire Hood Automotive design Automotive exterior
it is working fine but the bike keep jogging in high rpm the tank is a bit rusty from inside. I cleaned the throttles but no different the RPM is not steady. So any ideas?
BTW there’s no motorcycle garage in my city so i have to do it myself.
any help i cant wait to ride it again
 

·
You should listen to me. No, seriously, listen to
Joined
·
10,534 Posts
What year? Is that a dent in a frame rail? It doesn't look encouraging. I also don't know what that snarl of grey/tan stuff is below it. Or is it dirt that needs to be cleaned off? You should have traced the lead to see where it goes/went. Removing the splice leaves bare copper wiring that needs to be covered to prevent shorts and corrosion. It ought to be possible to remove the contact from the connector body and slide some heat shrink tubing over the contact to the exposed copper.
 

·
You should listen to me. No, seriously, listen to
Joined
·
10,534 Posts
^I don't know what's going on but your flag emoji has changed from what it was on Aug. 1. 45° C is hard for me to comprehend. I wilt at 38° C / 100° F.
 
1 - 10 of 10 Posts
Top