Suzuki GSX-R Motorcycle Forums Gixxer.com banner
1 - 3 of 3 Posts

· Registered
Joined
·
111 Posts
Discussion Starter · #1 ·
I ve made a few in the past, usually small 2-6 inch ones. I ve seen 8 long ones and wondered if anyone has used or know someone that has longer then that. I am just concerned since these will be bolt ons, that going that far out , say 10-12 inches is too much cantlever effect on the bolted area, or if I am just a worry wart ? I d hate to launch the bike at the drive in and leave the rear tire and extensions behind me LOL.

Thanks
 

· Registered
Joined
·
731 Posts
Haven't thought about that. I was toying with the idea of adding stock 4" above the bolt holes to help alleviate the stress on the bolted area. A snug fit should not have any problems with wear. Does anyone have a bolted on design that works on the older 1st gen gixxers?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top