Alternative to Pingel tap ?
1 - 3 of 3 Posts
Joined
·
1,619 Posts
https://www.mpsracing.com/products/MPS/Petcocks.asp
ACCEL makes high flow petcocks as well.
Although pricey, and shipping to England will be expensive...Pingel makes a quality product.
ACCEL makes high flow petcocks as well.
Although pricey, and shipping to England will be expensive...Pingel makes a quality product.
Joined
·
49 Posts
You could grab one off an older (84-86) GS1150EF, its only a single feed but the mount holes are the same. You keep the vacuum line they're only around 40 bucks.
Been using one on my 750 for a couple years, original used ones are always junk, (tried 3 so far) and new ain't in the budget.
Been using one on my 750 for a couple years, original used ones are always junk, (tried 3 so far) and new ain't in the budget.
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Billet Big Block for GSXR 1100W
Water Cooled GixxersHello! I am engaged in the development of a billet block for GSXR 1100W. The block will be used in the turbo engine, with a piston diameter of 77mm. I want to make liquid-cooled cylinder block. I think how to better to make channels for cooling? Someone have any photos of old big block for a...- 15
- 4K
-
Pasis · updated
-
Newbie.....Don’t shoot me down.....
Water Cooled GixxersHi all New to the site and gsxr’s. Been looking to do a street fighter project on one for ages. Picked up a nice 93’ 750WN. my question is, and I’ve searched til my fingers are numb, haha. I know the wheels from the RF 900 will fit but is it a straight case of swapping everything off of the...- 7
- 172
-
BrenK · updated
-
1992 6/11 build
Water Cooled GixxersOK guys, well I have been on the hunt for a 92 GSXR 600w for a couple years now. I bought one new off the showroom floor in 93 as a leftover and logged over 32k miles on it. It was a great fun bike for a number of years. About 2 years ago I found a set of NOS side panels for a bargain at a swap...- 40
- 3K
-
muckabucka · updated
-
Ready for another Gixxer Project
Water Cooled GixxersI sold orange and the honda 900rr. Kept the BMW. I m ready to start building a 6/11. I have a bunch of pieces to make a good start. Titled frame with sub frame Banana swingarm Fox shock w/ SRS Link Yoshi rearsets Rear wheel with rear brake system Linderman Steering damper Good gas tank that...- 49
- 3K
-
anthonyrr · updated
-
Fuel injection research
Water Cooled GixxersI am sure this has been asked before but I am asking anew. Who has converted their bikes to fuel injection? Not for turbo but normally aspirated? What throttle bodies did you use? I am asking this here because I have seen a working setup, albeit with turbo (which the guys i going to go...- 5
- 100
-
Neophyte · updated
Join now to ask and comment!