Double check everything is truly out via the number of pulled bolts and comparing it to the service manual, then use a rubber mallet and keep tapping around it until it comes out.
2006 GSX-R600 - Water pump doesn’t come off the engine
I am replacing the water pump of my GSX-R.
I drained the engine oil and the coolant, disconnected the hoses, undid the two 8 mm bolts. But the water pump does not come out. I can feel the pump moving a little bit, when I pull on it, but it doesn’t come out. Part of problem is that is difficult to get a good grab on the pump. Also, I don’t want to damage the pump, because I plan on overhauling it and keep it as a spare.
Any suggestions?
Thanks
I drained the engine oil and the coolant, disconnected the hoses, undid the two 8 mm bolts. But the water pump does not come out. I can feel the pump moving a little bit, when I pull on it, but it doesn’t come out. Part of problem is that is difficult to get a good grab on the pump. Also, I don’t want to damage the pump, because I plan on overhauling it and keep it as a spare.
Any suggestions?
Thanks
1 - 1 of 7 Posts
1 - 1 of 7 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Suzuki GSX-R Motorcycle Forums Gixxer.com
A forum community dedicated to the Suzuki GSX-R motorcycle. Discuss the GSX-R600, GSX-R750, GSX-R1000, and GSX-R1100, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
