Suzuki GSX-R Motorcycle Forums Gixxer.com banner
need help
1-17 of 17 Results
  1. 06-07 GSX-R600/750
    whats up everyone, im not new to the site but this is my first post so here it goes. responses and insight is greatly appreciated, tia. I have a 2007 gsxr 750, the ecu im using in it is a 600 ecu part # 32920-01H10 i need to flash the ecu to put a 750 fuel and ignition map on it. ive made a diy...
  2. 06-07 GSX-R600/750
    I was Riding With my buddies who also ride 600 when I noticed there bikes where running faster then mine where I was confused then when we came at a light a kid told us too rev our bikes each one by one all of there bikes where able too red line but mine it’s accelerated quick to 8 - 9k rpms and...
  3. 05-06 GSX-R1000
    So I have a K5 1000, and the clutch started slipping on it. It has very low miles so after doing some digging around I adjusted the cable at the perch and released some tension and it helped with the slip a lot. I figured it was slipping because the clutch wasn’t fully disengaging because of...
  4. 05-06 GSX-R1000
    idk whats wrong this time. Ive brought it back to life almost every time. But this one has me stumped. Replaced throttle boddys, replaced all 8 injectors, the wiring harness, and just about everything else Besides breaking into the motor. But now at any gear except 6th and when im doing a burn...
  5. F.A.Q.
    Hello looking to purchase my first bike. I’m looking at buying a 2011 gsxr 600 with16k miles. Is there any tips and tricks someone could tell me about the purchasing process or questions I should ask. Is there any certain things I should be looking at closely. Thanks
  6. 05-06 GSX-R1000
    Soo one day i went to start my bike and it sounded finny. Like it was running 3 cylinders. I tested power/continuity/ ohms on everyting that has to so with the coils, spark plugs, etc. Ive also compression tested the "dead" cylinder. But when you max wrist the bike its almost like they all kick...
  7. 08-10 GSX-R600/750
    I recently changed my sprockets and while removing the case for the front sprocket a rubber piece fell out. I am not sure where it fits into the case before putting it back on. Now when the bike starts there is a rattling noise where the clutch rod is near the front sprocket. I have a 2008 gsxr 750.
  8. 11 - Present GSX-R600/750
    Hi I am looking for suggestions of what to do with my 2016 GSXR 750, when I put it into gear from neutral it lurches forward and dies. When it is in gear I am not able to roll it back and forth with the clutch lever pulled in like normal. What should I do, I would greatly appreciate any help!
  9. SRADs (97-00 600 and 96-99 750)
    Hy I own a 600 SRAD from 1998 and facing a 3 cylinder working engine on it. The carbs have just been checked and tuned by the SUZUKI shop but after 10 miles the bike is running on 3 cylinder again. I've replaced the sparks by Iridium ones, changed the filters but no changes, the 4th cylinder is...
  10. 04-05 GSX-R600/750
    Hey guys, I'm new to this forum (hope I'm posting in the right place) and I don't know where else to turn to for this issue. I had a small oil leak form the water pump and followed SuperMotoRuss tutorial (which worked perfect besides my f*ck up). When I was putting the water pump back...
  11. 01-03 600 and 00-03 750
    So on my K3600 I keep blowing my 30amp Relay fuse and have been running trhiugh the whole harness testing for it grounding somewhere it should not be. On the plug that goes into my ignition there is a solid orange wire that is grounded but i dont think it should be. I need help understanding...
  12. 06-07 GSX-R600/750
    Hello all, thank you for helping in advance. I have recently started to do some work on the bike I’ve had for a few years now. It hardly ran when I picked it up but I needed a first time bike project. It’s an 07 GSXR 600. The issue: While riding around the town to see how everything is...
  13. 09-11 GSX-R1000
    I’m new to this forum but i have a k9 1000 i recently bought I’m trying to slam the bike for racing the fronts not a problem but the rear on other hand is a pain.. i purchased the triangle links with the different holes only lowered it so much then i read u also needed the adjustable screw bar...
  14. 04-05 GSX-R600/750
    So I ride a 04 gsxr 600 as my daily and only vehicle, earlier today I was out and about and noticed turning back onto my street coming home my speedo read zero after flipping my high/lows at a car to let them know they’re lights were off. So I pull into the driveway and flip the headlights one...
  15. GSX-R600/GSX-R750 General forum
    The other morning i went on a ride and felt my 2012 gsxr 600 wasn't accelerating properly once i got around 85mph (i couldn't feel power when i turned the throttle). Then i heard a very loud rattling noise caused by the engine vibration so i pulled off to the side of the road to find oil spewing...
  16. 05-06 GSX-R1000
    I rebuilt my front brake caliper Because it was gunked up with fork fluid now can’t get pressure at master cylinder have had numerous attempts with Miti vac Bleeder what could b wrong swaped master cylinder and same result
  17. Water Cooled Gixxers
    I have a 1993 gsxr 750w that seems to struggle when getting up to speed. And doesn’t like to get over 8k rpm. Seems abnormal. Anyone have suggestions on the possible problem?
1-17 of 17 Results
Top