Suzuki GSX-R Motorcycle Forums Gixxer.com banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 23 Results
  1. 06-07 GSX-R600/750
    So I am going to try to dumb this down and make it short and sweet. I was riding to an appointment I had with a client last Friday; and while I was on my way I started hearing a ticking/tapping/knocking (not great with engine sounds as I’m newish to dealing with engine issues) sound coming from...
  2. GSX-R1000 General Forum
    Hey everybody I just picked up a k4 gsxr 1000 limited edition black. I got the bike on a good deal because when I picked it up it would idle great but wouldn't rev past 3000 rpm, still shifted through every gear fine and was rideable. Figured I could clean the fuel pump or adjust stva and it...
  3. SRADs (97-00 600 and 96-99 750)
    I recently purchased a 1997 Suzuki GSXR-600 SRAD, and I took the gas tank off. When I go to re-install it the 'nozzle' on the Fuel Valve just came off, doesn't look like its broken its smooth and no sheered off metal bits but also no threads to re-attach it with? picture will show where its...
  4. General Bike Talk
    Recently bought a GSXR 600 it wouldn't rev past 4k rpm in all modes and gears it had a pretty bad rusted tank and clumped up fuel pump, i cleaned out both very well, put it all back together and still the same issue.. Should i buy a new fuel pump? Or try to clean out the injectors first with...
  5. 01-03 600 and 00-03 750
    So we have a 03 gsxr750 and we rebuilt the engine twice. Now we have this clanking noise that seems to be coming from the clutch maybe. But it only happens in neutral, now as we shift through the gears we lightly release the clutch (in neutral) and it starts coming back then we pull in the...
  6. 07-08 GSX-R1000
    I've been trying to find a rebuild kit for my clutch master but I can't seem to find it anywhere. Unless it's the same as some other bikes? I desperately need because this fluid is getting all over my fairings and I'm tired of either replacing them or repainting them.. Anyone have any idea where...
  7. 11 - Present GSX-R600/750
    I was just out at my bike to try and replace my CCT, but realized I don't have a hex key tight enough to get in there. So now I have a couple questions about replacement. 1. Can you remove the CCT without removing the valve cover and zip tying the cam chain to the sprockets? Or does that...
  8. 05-06 GSX-R1000
    So I have a K5 1000, and the clutch started slipping on it. It has very low miles so after doing some digging around I adjusted the cable at the perch and released some tension and it helped with the slip a lot. I figured it was slipping because the clutch wasn’t fully disengaging because of...
  9. F.A.Q.
    I recently bought a 2006 gxsr 600 which had a small fire at fuel rail to fix. It has a new wiring harness and the fire burnt all wires for sensors around motor (tps, injectors, speed sensor, gear shift sensor, crank sensor, coolant temp sensor) I’ve replaced all sensors and injectors replaced...
  10. 05-06 GSX-R1000
    I had it for a month it drove perfectly fine then one day it wouldn’t start, the fuel pump was priming and it cranked strong but no spark... I jiggled the ecu by accident and it work again.. then one day it happened again and it still had no spark... I replaced the ecu, spark plugs, and full...
  11. Member Introductions (No bike related problems)
    Hello everyone! I just took on a huge project and will be turning to YouTube and the forums for guidance. I am rebuilding a motorcycle that one of my buddies wrecked on. The frame cracked in the wreck so I purchased a new one and replaced the cracked one. I need advice on what type of tools...
  12. 05-06 GSX-R1000
    Hi all, First post here on gixxer and its because I’m in need of help! Bought a k5 liter-boy and didnt notice that the front right fork has a crack by the axle! Needless to say I’m super bummed, but is there a good way to repair this? I’ve done a fork seals/fluid on a couple other bikes (suzuki...
  13. 03-04 GSX-R1000
    Hey guys, little back story I bought a blown up 1000 a couple years ago did my homework and recently rebuilt the entire motor all new everything including the listed problem......the clutch.....bike is running and does so great BUT my issue is after making sure everything else was in tune I...
  14. 08-10 GSX-R600/750
    New to the gsxr world and I just grabbed a 09 750, the bike shows a - where the gear indicator would be and doesn’t change at all when gears changed (I cleaned gps and nothing) I also have a check. I tried to do the dealership paperclip trick and nothing showed besides chec still. I could find...
  15. 05-06 GSX-R1000
    in the market for a new fuel pump for my k6 1000, i see this one on amazon for 70 dollars.... im just a broke 27 year old but am still scared to buy it. its got great reviews and all that but part of me is telling me to not cheap out. 35k miles on my k6 1000... dont wanna buy a used one really...
  16. 06-07 GSX-R600/750
    Idk if I'm just dumb. But I can't find where the horn plugs in. I know it's mounted on the bracket with the rectifier but where's the cord to plug it in?? Is it on the main wiring harness?
  17. 04-05 GSX-R600/750
    Hey guys, I'm new to this forum (hope I'm posting in the right place) and I don't know where else to turn to for this issue. I had a small oil leak form the water pump and followed SuperMotoRuss tutorial (which worked perfect besides my f*ck up). When I was putting the water pump back...
  18. Two wheeled physics (Squid Farm)
    I have a 2007 GSX-R600 that won’t start up. It was riding fine the other day but now won’t start up at all. It sounded like a fuel issue because the bike was bogging and idling very low. Now when I turn the key it sounds like it wants to start but I get nothing. The bike starts with...
  19. SRADs (97-00 600 and 96-99 750)
    Hello everyone. I really need some guidance with a situation I have going on. I have a 96 gsxr750 with a KN filter but I believe it’s the original box. I have a Yoshimura RS-3 exhaust I have cleaned the carbs before on the bike and put them back together with no issues other then not being...
  20. SRADs (97-00 600 and 96-99 750)
    Was running great until I ran thru a hole in the road.my bike is lowered so i heard it scrape .get home ten mins later and right when I get on my street my motor started making this knocking sound .could my exhaust be loose could it be misfiring ,maybe a cam chain tensioner? Please I really need...
1-20 of 23 Results
Top