Search Results for ‘ecu’

Hey guys i really need some help with my03 gsxr 600. It has no spark . Previous owner told me that he was on the highway and the bike started slowly loosing power. Battery was budging, rectifier was burning hot and coil 3 was completely burnt. Before he sold it to me he said he changed the ecu...

The previous owner of my bike changed the stock exhaust with a slip-on. When I got the bike I had FI light code on the dash. This code was the C46. After I did my research I found out that it had to do with the SET valve. Thus, I went to check what the issue could have been. I saw that the...

Hi everyone. New to the forum, been riding my Gixer for 15 years. I have a problem I am stuck with and I am hoping to learn from the wealth of experience here. The Bike My bike is a 1998 750 GSXR SRAD Fuel injection running a power commander 2. The Background Bike was running fine. Stopped...

I fried my ECU while using a car to jump my battery after my rectifier went bad facepalm. Just replaced the ECU and the bike starts but now what seems like randomly, the bikes idle slows significantly, and the exhaust note is much deeper. When this happens I also have only about 80% of power...

I was riding my 06 GSXR 750 a few weeks ago when my bike completely shut off, engine and dashboard. I pulled over to the side of the road. I assumed my battery was dead, so I ignorantly used a police tahoe to jump the bike while the tahoe was running. My bike started tho for about 3 minutes I...

I have a K5-1000, on hot days during long rides the bike shuts off when 'heat soaked' (riding long enough for entire bike to be warm-not just engine). Not over heating (178-200+ deg don't matter) If I'm in traffic it may happen sooner as opposed to being on the highway on a hot day. It...

Hello guys, i am new here, just wanted to ask which is the best performance exhaust systems for GSXR1000 2016. I have a Chinese cheap slip on Brocks and want to change it either with full system or original slip on. The bike ECU has been reflashed and i install sprint air filter and new spark...

I have a 2012 600 and I am going to be putting a M4 slip on but want to cut the cat converter off. Do you have to do an ECU flash if you cut off the cat converter to put a mid pipe on?

Hey everyone, Bought a k7 750. F1 light is on like everyone else. The bike has no cat and aftermarket exhaust. Ran for about a couple of km/miles then it started studdering. Thought it was the rec but check and wasnt popped. Checked for codes by using the safety pin in white clip and shows C00...

Hey, guys. I picked up a GSX-R 750 K1 a few months ago and would like to get a power commander for it. It has a yoshi rs-3 exhaust on it, but there's no lean condition on decel and the throttle response is choppy-- which leads me to believe the bike was "mapped" with a YAFMS (yosh box). Is there...

is It possible to store two maps within the Ecu and switch between the two if so how

Have a 98 gsxr 600 an jus picked up a pc3 for a killer deal. Are there maps for a 98? Have never used a tuner but hear they have phenomenal results forgive me if i sound like a goof. Any pointers or knowledge are greatly appreciated!

Hello guys, So, i´m new here in the forum, but i´m also new working with ECUs and stuff like this... I normally work on Car/Trucks ECUs / Engines, but now i need some help from the Experts here because i´m helping a friend on his bike that has No Spark. So, he told me that the bike was running...

Hi all, I am new to this forum and new to Gixxer line. Recently I purchased FTECU data link, when I tried to install, I realise some ports that the FTECU hardness requires, has been taken up by other pins. (Not sure if the previous owner did anything to it.) So I tried to remove the...