Suzuki GSX-R Motorcycle Forums Gixxer.com banner

Search results

1-9 of 9 Results
  1. 1988 GSXR Carb Sync Issues

    Oil Cooled Gixxers
    unless you are pinching pennies Id replace all of it.
  2. '90 GSXR 750 loss of power

    Oil Cooled Gixxers
    I would plug chop to see if its a mixture issue
  3. 1988 GSXR Carb Sync Issues

    Oil Cooled Gixxers
    I assume you are saturating the screws with penetrant. my favorite cocktail for this is 50/50 ATF and acetone. Works better than any off-the-self penetrant. I have used a impact driver wth success in similar applications, have you tired it to make sure there is no room? worst case scenario you...
  4. '90 GSXR 750 loss of power

    Oil Cooled Gixxers
    I once ordered a carb rebuild kit for a KZ750 and it came with 2.0 float valves, i didn't look at them and assumed they were correct for the model. On the highway it would loose power when i gave it wide open throttle until i backed off a little and the float bowls refilled. I switched to 2.5...
  5. Thrown rod or blown engine? how did it happen and what to do next

    Oil Cooled Gixxers
    That is some real carnage. if youre going to rebuild that you will need to check everything over very carefully. I know you're attached to the engine for sentimental reasons, but if your cases are cracked I think its a loosing battle.
  6. Dirtbag oil-boiler ('86 750)

    Oil Cooled Gixxers
    its a small world for these ol gsxrs
  7. 1988 GSXR Carb Sync Issues

    Oil Cooled Gixxers
    If yo I think you need to carefully inspect the boots. the fact the RPM did climb when you sprayed carb cleaner there is a strong indication of a vacuum leak.
  8. Dirtbag oil-boiler ('86 750)

    Oil Cooled Gixxers
    My good friend styled me with a carbon fiber fairing for this project. normally I would say carbon fiber is too good for a dirtbag project such as this. However, the carbon version was made cheap and quick by pulling a positive off my hacked together original. No mold was made, so it’s a bit...
  9. Dirtbag oil-boiler ('86 750)

    Oil Cooled Gixxers
    How do I get the crossover cans on this duplex to seal? There is a pretty big gap between the can and the header.
1-9 of 9 Results
Top