Not sure of the price. Wanted to see what the xro guys on here thought about them. Don't know much about them other than someone told me they were off an xro 4. Wanted to see if anyone could confirm or if its possible to even tell.
Sie has a set and they look the same. He will be loged on in a few hours and he will give you a straight answer. It's 5.41 am here.
If there the right price I would buy them, investment if ya hear me looking at ya.
Motorcycle: gsxr k1 1000 184.5 rw bhp ex race bike day time mot project and xro7 project build
Posts: 1,139
Re: who can identify these?
yep they look like XR04,.. not for the srad ones ,but still factory parts very nice and good condition....and nice to see with the correct spindle,these look like a new unused set,so may be set up for the kayaba forks,if unstrapped xro4,id think they are the kit parts for the slingshot,but the magnesium does point to works item.
Last edited by speedy sie; 02-11-2012 at 05:12 AM.
They are stamped xro 4 37. 37mm offset. So these aren't for a srad, too bad. Unless you get a bunch of additional parts? Can i make these work on a 97 srad? They do measure 50 on top and 54 bottom.
Motorcycle: gsxr k1 1000 184.5 rw bhp ex race bike day time mot project and xro7 project build
Posts: 1,139
Re: who can identify these?
Quote:
Originally Posted by williamhbonney
What would I need to do to make these work?
just the stem may needed to me worked on,as all the works bikes had one off frames,so may need work.
to get later xro5/6 or xro7/8/9 yokes is big money and can run in to many £1,000's if the set is complete with all the inserts and fork colliers.
these all came from henry he had the last 10sets as they were getting throwen out,they were for the Wn series off bikes also were made at yoshimura and then stamped with the model number.
Linear Mode
