Need help on fabrication of a SPRAY BAR.I have a complete wet system setup ( fuel ,nos selenoids, activation switch,and tps wide/open sensor switch and lines, wet fogger, ,jets) but it has only a single WET FOGGER .What i want to do if possible is run a spray bar directly thru air box,over throttle bodies( STACKS ). then drill out 4 tiny holes in bar,directly over runners. OK here is where it gets sticky , the NOS and FUEL jets get installed at the FOGGER, then thread the spray bar over fogger. You see the Gas to NOS ratio is done at the fogger,here is where the two meet and mix. Another thing is the fuel pressure on 05 1k is 43 psi,to the injectors where i will Tee off from, for fuel supply. Is thats enough fuel pressure ,when spraying ?and still supply the 8 injectors with enough psi. or will i need another fuel pump?