Ok heres a stupid question I am sure that is asked a million times.I have an 05 GSXR 600 (Ya first bike) and I put a HotBodies undertail on it. After hooking the lights up, the turnsignals flash like a Vegas casino!

Here's the obvious question:
Is there any way to make the turn signals flash a bit slower?

I figured this was due to an imbalance or improper resistance on the T/S flasher circuit so I checked that out....The resistance on the standard bulb and socket is around 1.3 Ohm. I checked the left side of the new undertail T/S and it was around 16.5 MOhm.

I have a tech question written to the company and am waiting a response from them. If and when I hear from Hotbodies, I will post the findings. I was hoping someone here already figured it out.

Thanks for reading and helping!
Andy
www.calamityjames.com (http://www.calamityjames.com)

Go to Radio Shack and buy a resistor, put it in line and you're done.

What RookWV said!

Go to fendereliminator.com they sell the resistors to slow the flashing down like they are the stock ones.

Follow this link to a bulletin board posting that discusses this. Someone even created a make-shift wiring diagram for you to follow.

http://www.gixxer.com/ubbthreads/showflat.php?Cat=0&Number=1598103&an=0&page=0#1598103

Follow this link to a bulletin board posting that discusses this. Someone even created a make-shift wiring diagram for you to follow.

http://www.gixxer.com/ubbthreads/showflat.php?Cat=0&Number=1598103&an=0&page=0#1598103



That's a good informatinve post!!