just got my PCIII USB in from FUEL MOTO. He put a custom map on the commander for my 600 with a BMC filter, TRE, and a bolt on. I rode all day today and I must say that this map is killer. Pulls so hard!

There is one problem! Ever since I put on the pipe the damn thing has been really rough on idle, and the map on the PCIII did not help. Also, it has a terrible flat spot up to 3000rpm, stumbling until you get through it. The PCIII did not help here either. The map that he gave did not make any 0 throttle adjustments or any below about 1750prm.

So I saved the original tune on to the laptop. Sat down and looked at the 0, 2, and 5 % throttle in the first 10000 RPM and made some changes to the table where there were all zero's. So far I have almost completely eliminated the lopey idle and the stumble from idle to 3000rpm. I still have some work to do on it but I would say that its 90% completed.

My question is, how many people would be interested in receiving this map?

What would i do with it exactly? I have a yoshi bolt on and a tre and soon getting a K&N airfilter but i cant buy a power commander until i pay off the bike. Mine does the same thing though with the bumpy idle and it's really slugish around 3000rpm. But if you could help me out with it since i dont know a whole lot about the remapping and everything.

BillyGoat said:
just got my PCIII USB in from FUEL MOTO. He put a custom map on the commander for my 600 with a BMC filter, TRE, and a bolt on. I rode all day today and I must say that this map is killer. Pulls so hard!

There is one problem! Ever since I put on the pipe the damn thing has been really rough on idle, and the map on the PCIII did not help. Also, it has a terrible flat spot up to 3000rpm, stumbling until you get through it. The PCIII did not help here either. The map that he gave did not make any 0 throttle adjustments or any below about 1750prm.

So I saved the original tune on to the laptop. Sat down and looked at the 0, 2, and 5 % throttle in the first 10000 RPM and made some changes to the table where there were all zero's. So far I have almost completely eliminated the lopey idle and the stumble from idle to 3000rpm. I still have some work to do on it but I would say that its 90% completed.

My question is, how many people would be interested in receiving this map?



Probably a little late on this thread but get rid of the TRE and then see if you still have trouble in the low revs.

i would be interested in it

Sorry, I just saw that you all posted... No one did for so long that I gave up. I have modified the map twice now and it runs pretty good now. I will see if I can get the latest up here in a couple days.

I have the latest map that I am using on my 04 GSXR600. I have the following mods:
+2 rear sprocket, BMC air filter, race pipe, TRE, PCIIIUSB

Please post email address or PM me and I will send it to you.

Have you dyno your bike? I'm curious to find out the hp and torque? How is your low/mid powerband? e-mail me at gixy05@hotmail.com thx!

I have not dyno'd the bike... Yet.

What map are you using? I've had the same problems?