Hi mates,

When i was about to start my 1 year old k9 600 with 15k km done.
The speedo where displaying temperature was flashing between "FI" and the temperature.
There was no specific code displaying.

When i tried to push the button to start the bike, rpm goes up to 1.5 and immediately drops to 0.
Kept cranking start but it just wont work.
After a few tries and i switch the ignition on and off and tried reving the bike for a few mins then it get started.
and the bike seems fine after that.
I had already removed my SET valve around 6 months ago

Any idea what has happen?
i could not tell as no specific codes were thrown.

Please help.

Thanks & Regards
Joseph

click my youtube link below and watch the vid on how to adjust the TPS. The point of the vid is to show you how to put the bike in dealer mode and get the codes.

or you can go to bugmanweb.com or search this site.

once you get the code - post up.