I got my project toghether enough that I could take it for a test run. It runs great!!

But after I brought it back to the shop and was getting ready for my 2nd run. It started screwing up.

It would start fine and idle fine but when I put it in gear it would die. Is there a saftey switch some where? If so how can I overide or jump it to make sure it's what is causing the prob?

Thanks,
Jeremy

its probably your kickstand switch either replace or jump the two wires together just make sure you remember to put up your kickstand before taking off

I'll check that out, Thanks. I was hoping that it wasn't much.