11-26-2009, 08:12 AM
i have a 04 gixxer 1000 and im putting a NOS kit on it, i have a 3 way toggle switch and it came with the system. i dont know which wire from the start button goes to the toggle switch. the toggle switch takes 3 wires one from nitrous solenoid and one from the start button(but i dont know which one) and one more i think its a 12v switch power. does any one have install photos or step by step instructions. that would help me because what the company sent me is not helping me at all.
11-26-2009, 06:54 PM
from what ive seen on my buddys bikes...my personal opinion is that its better to have the throttle activate the solenoid..i would NOTwant to take any fingers of the throttle to press the nitrous..they put it in so that when u open full throttle it activates and since you have your hole hand wraped on the throttle(without taking the thumb finger off)its easy to ease off the throttle if something goes wrong.......
11-28-2009, 06:45 PM
i got the nos system installed and wired, its pretty easy once you know the wires
11-29-2009, 11:52 PM
be careful if you are driving the solenoid straight off the stater wire and not using a relay. It will probably eventually burn the wire up.