msthtd
12-10-2003, 10:32 AM
hey folks:
this is a continuation from a previous post.....the remnants of my duplex full exhaust...missing one flange.....the shop put it on a while back ...i just paid for it so i don't know if these are the right flanges in the first place......if they are..does anyone know where i can get one or a complete set.....does anyone know if another yosh system can replace the flanges without restrictions....cause yosh doesn't make anything below 96' anymore..go figure....thx for the help http://www.gixxer.com/uploads/P10100848.JPG[/image]
GixxerRacer317
12-10-2003, 11:32 AM
Yeah those are the correct flanges...... I found a set just like them on ebay a few months ago and I was tempted to buy them but since I already fixed my problem I couldn't justify buying them......... if all else fails you could always take the other one(in the middle) to a machine shop and they could duplicate it for you.......
FastCat
12-10-2003, 11:35 AM
GixxerRacer317 said:
......... if all else fails you could always take the other one(in the middle) to a machine shop and they could duplicate it for you.......
That's what I'd do in that boat... assuming, of course, that repeated threats and frightening away customers didn't convice the shop-in-question to suddenly REMEMBER what they did with my flange...
FastCat said:
GixxerRacer317 said:
......... if all else fails you could always take the other one(in the middle) to a machine shop and they could duplicate it for you.......
That's what I'd do in that boat... assuming, of course, that repeated threats and frightening away customers didn't convice the shop-in-question to suddenly REMEMBER what they did with my flange...
http://www.gixxer.com/forums/images/graemlins/applause.gif
Yep, thats what I would do....shops generally don't like to have customers scared....
http://www.gixxer.com/forums/images/graemlins/crazy.gif
-Karl
msthtd
12-11-2003, 07:50 AM
THX cat and 317..you too Karl.....now i have to look for a dependable shop around here....any special shops with special machines or ?????
FastCat
12-11-2003, 09:57 AM
Any place that describes itself as a "machine shop" should be able to easily handle that... it shouldn't take more than an hour or so to do.
...if you're in the Seattle area, I know a good local machine-shop... and of course, if you're in newport news, VA, I know a good one there too http://www.gixxer.com/forums/images/graemlins/smile.gif but otherwise, let your fingers do the walking.
msthtd
12-11-2003, 01:04 PM
the bad thing about living in the bay area is that everything is here....but too damn far http://www.gixxer.com/forums/images/graemlins/laugh.gif