gunslinger
10-02-2003, 02:18 PM
I just installed the TRE on my 2002 750. I didn't notice much of a difference in performance. I understand that the gain is minimal and that's O.K. but now my neutral light doesn't work. Is this normal?
|
: Installed TRE now no neutral light Taz 10-02-2003, 02:22 PM Did you cut or damage the "Blue wire". Must never cut the blue wire. gunslinger 10-02-2003, 04:44 PM No, I didn't cut any wires. It is just a plug in model. It has 3 wires. The only thing I don't like is no neutral light and I can't start the bike with the kick stand down. Dingo3243 10-02-2003, 05:57 PM gunslinger said: No, I didn't cut any wires. It is just a plug in model. It has 3 wires. The only thing I don't like is no neutral light and I can't start the bike with the kick stand down. Unplug it and see if it still happens. It sounds like a totally different problem. Taz 10-02-2003, 07:03 PM Definitely sounds like the blue wire. If you take the TRE off measure resistance from connector to connector (on the TRE) where the blue wire would plug in on each. It should be 0 ohms. When you pulled the connector apart on the bike did you grab it by the wires? Could have pulled the wire out of the spade or lug in one of the connector. Chris023 10-02-2003, 09:12 PM I noticed the same thing on my 01 750 race bike when I installed a TRE. I was told you must bypass the TRE for the green wire. Will check into that this weekend. g2driver 10-02-2003, 09:35 PM Yes, please let us know, as I've ordered a TRE for my 2001 750 as well. Thanks, Raj silverbikeman 10-02-2003, 11:43 PM Hmmm, I did the cheap hard wired 25 cent resistor for the TRE, no neutral light problems. http://www.gixxer.com/forums/images/graemlins/grin.gif EBT531 10-03-2003, 04:59 AM Something is wrong. I have a plug-in version and have a neutral light and always start the bike with the kickstand down. NVR2FST 10-03-2003, 09:04 AM I put a TRE on my 01 750 and have had no problems... it works pretty well a little better performance...and actually better gas mileage with it too... you must have gotten a bad one... gunslinger 10-03-2003, 04:10 PM I found the problem. I bought the TRE from a guy on the forum and when I went to wiggle the connector to make sure I had a good connection, all 3 wores pulled right out. I need to get one from JSD. I may also try to fix what I have if I can get the pins out of the connector. NastyC4 10-04-2003, 04:16 AM guys what's a TRE ?? http://www.gixxer.com/forums/images/graemlins/confused.gif alumahorse 10-04-2003, 05:09 AM NastyC4 said: guys what's a TRE ?? http://www.gixxer.com/forums/images/graemlins/confused.gif search in the mods and how to's. You'll be busy all weekend. | ||
vBulletin® Copyright ©2000-2012, Jelsoft Enterprises Ltd.