Yesterday, after my last run at a track day, my bike felt down.!!!! while it was on its stand. I did not put the frame sliders yet !!!

This is the reason of this post.I have a friend who can make those frame sliders. But I need a schematic drawing with dimensions to be able to make them. Especially because I do not want to dril in the fairing for the left one. GSXR750K3

If you have those sliders, could you help me? http://www.gixxer.com/forums/images/graemlins/wink.gif

Cut the left fairing.

I've seen guys who used teh intuitive bracket setup -- it's okay for low speed stuff, but for track use, it just makes damage worse.

Use a dremel and you can't notice the cut fairing if you cut well/measure properly.

Actually my next question was about the strength of the extension part of the left slider.

Okay for 0 kmh/low speed stuff. Anything over 40 mph, it makes things worse.

Cut your fairings, use the engine motor mount bolts.

Bump. Can anyone help out with measurements? Length, daimeter, and bolt size. I'd like to make a set as well.

Ok, I think I will cut the fairing. http://www.gixxer.com/forums/images/graemlins/applause.gif

just cut the fairing. you dont want the bracket for track use.