What, if any, anti-vibe bar ends have you guys tried putting on? I want something to quell the vibration a bit, without resorting to jelly-gel grips. Or are all racers hard as nails and don't care about a pansy thing like this? http://www.gixxer.com/forums/images/graemlins/laugh.gif

I love my woodcraft clip-ons But i don't feel any vibes in mine, maybe you need to loosen your grip http://www.gixxer.com/forums/images/graemlins/wink.gif

ditto, my hands are fine, no buzz, nothing.

Loosen up pal. http://www.gixxer.com/forums/images/graemlins/thumb.gif

PDG said:

ditto, my hands are fine, no buzz, nothing.

Loosen up pal. http://www.gixxer.com/forums/images/graemlins/thumb.gif



Yea nothing here either

I can definitely notice a vibration going from my track bike to street bike--also, when I went from my stock clip-ons (with those bar ends with rubber plugs) to the Woodcraft (with just a plastic cap at the ends)...trouble is the Woodcraft tube is slightly different diameter than stock...

Just look around at your local dealers accessories aisle. Most aftermarket bar-ends will fit. They've got a rubber washer that expands under the pressure of the bolt being tightened. And by the way, mine don't vibrate either.

no problems here.... at all.... http://www.gixxer.com/forums/images/graemlins/dunno.gif

no problems here.... at all.... http://www.gixxer.com/forums/images/graemlins/dunno.gif

mine vibrate like hell.. to the point that my right hand is numb by the end of a race. But then again I suck

I use Intuitive bar end sliders and the stock bolts and rubbers. Took a bit of WD-40 to get then in (the rubber grommets) but they worked great and have been crashed tested I'm sorry to say.