http://www.gixxer.com/uploads/1fighter1.jpg

I'll write more later when I'm not at work.

U need to loss the stock head light and get a smaller one thats more like this pic

http://www.gixxer.com/uploads/SXRSTREETFIGHTER.jpg

Welcome to the Board. Nice start.
Bones

Yep that head light will be gone as soon as more money arrives. I've got alot of ideas for it, just got to wait on the paychecks to roll in.

Does anyone have a good place to purchase/shop for some braided hoses for the radiator. I seen some at Pep Boys but one hose was like 30 bucks. Plus it was probably much longer than I need since it was for spurcing up a car instead of a bike.

I got my start about 1 month ago by wrecking off my plastic. A stupid pass going into a blind left turn resulted in a high side into a Kenutcky ditch. Instead to buying new platic I purchased Sidi race boots and a scotts damper.
I've managed to hide most of the wire loom to the front end and also relocated my coolent overflow under my gas tank right behind my carbs. The bike is pretty much stock except for EBC Prolite roters, braded lines, and a yosh race slip-on.

Next step is a valve and carb adjustment since it has 40,000 miles and nothing has been done to engine yet. I'm planning a photo shoot with my buddies digital camera. I'll post more pictures when I can.

By the way some of the best wrap for any wiring job is this stuff call cold shrink wrap tape. The stuff is my new best friend.

nice start... check this one out http://www.gixxer.com/forums/images/graemlins/cool.gif not bad for a little inspiration!
http://www.gixxer.com/uploads/gsx297a.jpg
http://www.gixxer.com/uploads/gsx297b.jpg