Hi ;)

this problem does not occur always:

When i try to start, i press ignition button (wen pressed in) i only hear the sound of the fuel pomp but no sound of the starter. (so the starter doen't run)

when i hold the ignition buttun for a while there apears a FI code on my display.
I checked the FI code (with the paperclip trick) and when it's in dealer mode there i saw C11 and then C12 . (the two codes are switching continuously at a constant speed(rhythm)

I don't believe the problem is a crank shaft or camshaft pos sensor problem.
Because i can run the engine if i push the bike on, it will run easily. I think that the ECM is a bit confussed because the starter isn't working???

so:

When ignition button is pressed: no starter, fuel pomp & ignition are working
i can push the bike and then it will run.
bike: GIX 1K K3 (with full akra system)


please help

best regards ;)

try checking your kick stand sensor and your release pin sensor just under the clutch handle.

How hard is it to pull the starter ? might be easy enough to pull it out & have it tested this will eliminate one problem source.

Have you tried to reset the ecu or cpu ?