10A fuse blowing
I am working on a wrecked bike converting it to a track bike. Its not starting now after I worked on some electrical things.
First I removed all the pins out of the connector on the main harness that goes to the headlight harness. The connector was busted from a wreck and I am going to hardwire the headlight harness to it. But for now all the wires are separated and not touching the frame.
Second I pulled the spark plugs cleaned and reinstalled them.
Third and I think this is somehow where the problem lies is that I did a quick clutch bypass to remove the left pod. I put the b/w and b/y wires together.
As soon as i connect power it blows the ignition fuse and the fuel pump wont prime. If I unattach the b/w b/y wires everything works up until I push the starter which obviously doesnt do anything.
Any insight? I am thinking a grounded wire somewhere I am missing.