Re: Motor studs?
Go with Lukes recommendations on the head studs if he has actually used them , i was fairly sure the bolts/studs would interchange
the main studs will interchange, i have a set here that measure 108 long including the top thread for the nut
be sure the main studs have clearance in the cases, i am currently changing a set of main bearings that measured up good with bolts, but then i changed to studs by just swapping them out , and ran the bearings first use, lucky it was not bad enough to heat or hurt the crank, just the motor smelt bad and i went looking
hey i just brought some carrillos for your model, several sets of old stock , going to modify at least one set to fit the srad.
just let me know about the plenum , i need lots of notice as work is flat out , doing 16 hr days